CUSTOMIZE PARAMETERS
CUSTOMIZE LTA
NOTICE:
(a) Customizing with the Multi-information Display
(1) Turn the engine switch on (IG).
(2) Select the setting by referring to the table below.
(3) Using the steering pad switches, change the customize settings.
HINT:
Each item is displayed on the "Setting" tab on the multi-information display.
LTA| Display | Description | Setting | Default |
|---|---|---|---|
| Lane Center | Lane centering function setting | On/Off | Off |
| Steering Assist | Steering assist function setting | On/Off | On |
| Alert | Method of lane departure alert | Steering vibrator/Buzzer | Steering vibrator |
| Sensitivity | Lane departure alert timing | High/Standard | High |
| Sway Warning | Vehicle sway warning function setting | On/Off | On |
| Sway Sensitivity | Sway warning sensitivity setting | High/Standard/Low | Standard |
HINT:
Some LTA functions are operable only when other functions are enabled or operating. Refer to the following table.
| Vehicle-to-vehicle Distance Control (With Full-speed Range Following Function) | LTA Main Switch | Steering Assist | Lane Center | Sway Warning | |
|---|---|---|---|---|---|
|
●: System/function operating
○: Turned/Set to On | |||||
| Lane Departure Alert Function | - | ○ | - | - | - |
| Steering Assist Function | - | ○ | ○ | - | - |
| Lane Centering Function | ● | ○ | ○ | ○ | - |
| Vehicle Sway Warning Function | - | - | - | - | ○ |
How To Proceed With Troubleshooting
Problem Symptoms TableLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Door: Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front door disassembly/reassembly are shown below. Necessary Procedures After Parts Removed/Installe ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Starter: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installe ...