REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Millimeter wave radar sensor assembly | Adjust millimeter wave radar sensor assembly |
| |
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here
2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
| (a) Disconnect the connector. |
|
(b) Remove the 2 bolts and screw.
| Bolt |
| Screw |
(c) Disengage the 2 guides and remove the millimeter wave radar sensor assembly.
NOTICE:
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.
Components
AdjustmentLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Parking Light/Daytime Running Light Circuit
DESCRIPTION Parking light function:
When the main body ECU (multiplex network body ECU) receives the light control switch position signal, it sends an illumination request signal to the No. 1 headlight ECU sub-assembly and illuminates the parking lights.
Daytime running light function:
When ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Console Box: Installation
INSTALLATION PROCEDURE 1. INSTALL CONSOLE BOX ASSEMBLY (a) Engage the 6 guides as shown in the illustration. Install in this Direction (b) Connect each connector. (c) Install the console box assembly with the 4 bolts and 2 screws. (d) Connect the connector. (e) Engage the clamp. (f) Engage ...