INSTALLATION
PROCEDURE
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
NOTICE:
If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
(a) Engage the 2 guides.
| Bolt |
| Screw |
(b) Install the millimeter wave radar sensor assembly with the 2 bolts and screw.
Torque:
Bolt :
2.5 N·m {25 kgf·cm, 22 in·lbf}
HINT:
Tighten the bolts and screw in the order shown in the illustration.
(c) Connect the connector.
2. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
3. ADJUST MILLIMETER WAVE RADAR SENSOR
(a) When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click here
AdjustmentLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering System: Adjustment
ADJUSTMENT PROCEDURE 1. STEERING WHEEL OFF CENTER ADJUSTMENT PROCEDURE (a) Inspect steering wheel off center. (1) Turn the steering wheel assembly to the center position. (2) Apply masking tape to the top center of the steering wheel assembly and upper steering column cover. *1 Ste ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Compressor: Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor and magnetic clutch with a new one: (1) Remove the drain bolt (seal washer) from a new compressor and magnetic clutch. *a Drain Bolt (Seal Washer) (2) Gradually discharge the inert gas fro ...