DESCRIPTION
When an incorrect ECM, main body ECU (multiplex network body ECU) or skid control ECU (brake actuator assembly) is installed after the assist map has been written to the power steering ECU assembly, DTC C1582 is stored because the information stored in the power steering ECU assembly does not match the vehicle specifications.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1582 | Assist Map Number Mismatch | Assist map number mismatch |
| EPS warning light: Does not come on | Assist Map Writing is performed or the power switch is turned on (IG) again | - |
CAUTION / NOTICE / HINT
NOTICE:
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click here
HINT:
Related parts store information necessary for assist map writing.
Related Part:
PROCEDURE
| 1. | CHECK CAN COMMUNICATION SYSTEM |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
| B | | GO TO CAN COMMUNICATION SYSTEM |
|
| 2. | CHECK RELATED PART |
(a) Check if the part below has been replaced with an incorrect part in the past.
| Related Part | ECM |
| Main body ECU (Multiplex network body ECU) | |
| Skid control ECU (Brake actuator assembly) |
NOTICE:
When removing the related part to check it, be sure to follow the appropriate procedures and precautions.
Click here
Click here
Click here
(b) When DTC C1582 is output and parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.
NOTICE:
If the power steering ECU assembly has been replaced, perform assist map writing.
Click here
| Result | Proceed to |
|---|---|
| The related part has an incorrect part number. | A |
| The related part has the correct part number, or a related part and power steering ECU assembly have not been replaced. | B |
| B | | REPLACE POWER STEERING ECU ASSEMBLY |
|
| 3. | REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER |
(a) Replace the related part with one that has the correct part number.
Click here
Click here
Click here
|
| 4. | CHECK FOR DTC |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
| A | | END |
| B | | REPLACE POWER STEERING ECU ASSEMBLY |
Assist Map Number Un-Writing (C1581)
CalibrationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Power Seat Control System(for Second Row): Power Source Circuit
DESCRIPTION Power is supplied to the fold seat control ECU through the ECU-DCC NO. 2, P/SEAT R/R*1, P/SEAT R/L*2 and ECU-IG1 NO. 4 fuses.
*1: for Rear Right Seat
*2: for Rear Left Seat
WIRING DIAGRAM CAUTION / NOTICE / HINT HINT: Inspect the fuses for circuits related to this system before ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: Weather and traffic information cannot be obtained
CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System. Click here PROCEDURE 1. CHECK COVERAGE AREA (a) Check that th ...