INSTALLATION
PROCEDURE
1. INSTALL STEERING VIBRATION AND HEATER ECU
(a) Connect the connector to the steering vibration and heater ECU.
(b) Install the steering vibration and heater ECU to the lower steering wheel boss cover with the 2 screws.
NOTICE:
If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.
(c) Engage the 2 claws to install the lower steering wheel boss cover to the steering wheel assembly. |
|
(d) Install the screw.
(e) Connect each connector to the steering vibration and heater ECU.
(f) Engage the guide to install the wire harness to the lower steering wheel cover.
2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
for U881F: Click here
for U881E: Click here
3. INSTALL STEERING PAD SWITCH ASSEMBLY
Click here
4. INSTALL CRUISE CONTROL MAIN SWITCH
Click here
5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
6. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
7. INSTALL STEERING WHEEL ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Camshaft Oil Control Solenoid (for Bank 1): Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION:
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not t ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Can Communication System: Open in One Side of Bus 5 Branch Line
DESCRIPTION If an ECU or sensor is not displayed on the CAN Bus Check screen of the Techstream and some ECUs and sensors repeatedly appear and disappear from the screen when the CAN main bus lines are normal (there is no open, short, short to +B or short to GND in the main bus lines), there may be a ...