PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Transfer System| Symptom | Suspected Area | Link |
|---|---|---|
| Noise in transfer | Oil (level low) | |
| Backlash improperly adjusted | | |
| Preload improperly adjusted | | |
| Tooth contact improperly adjusted | | |
| Transfer bearing assembly (wear) | | |
| Ring gear mounting case bearing (wear) | | |
| Oil leak from transfer | Oil (level too high) | |
| Oil seal (worn or damaged) | | |
| Oil seal RH (worn or damaged) | | |
| Gasket (damaged) | | |
| Seal packing (damaged) | | |
| Front drive shaft oil seal RH (for Inside) (worn or damaged) | |
PrecautionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System): Rear Sensor Communication Malfunction (C1AED)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the ECU, or when there is a malfunction in a rear sensor. DTC No. Detection Item DTC Detection Condition Trouble Area C1AED Rear Sensor Communication Malfunctio ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headup Display Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL HEADUP DISPLAY SWITCH ASSEMBLY (INTEGRATION CONTROL AND PANEL ASSEMBLY) (a) Engage the 4 claws as shown in the illustration to install the headup display switch assembly (integration control and panel assembly). Install in this Direction 2. INSTALL LOWER I ...