INSPECTION
PROCEDURE
1. INSPECT STEERING HEATER SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
| (a) Measure the voltage according to the value (s) in the table below. Standard Voltage:
HINT: As the circuit has a diode, perform the measurement in diode test mode, and do not mistake the polarity. |
|
(b) Measure the resistance according to the value (s) in the table below
Standard Resistance:
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 4 (IG1) - 16 (ECU) | Steering heater switch (Integration Control and Panel Assembly) is pushed | Below 1 Ω |
| Steering heater switch (Integration Control and Panel Assembly) is not pushed | 10 kΩ or higher |
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Telephone And Gps Antenna (for Roof Side): Components
COMPONENTS ILLUSTRATION *1 TELEPHONE AND GPS ANTENNA ASSEMBLY *2 TELEPHONE AND GPS ANTENNA ASSEMBLY WITH COVER *3 COVER *4 WASHER AND HOLDER *5 SEAL *6 TELEPHONE ANTENNA HOUSING N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Mass Air Flow Meter: Inspection
INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY (a) Perform a visual check for any foreign matter on the intake air temperature sensor (thermistor) of the mass air flow meter sub-assembly shown in the illustration. OK: There is no foreign matter. If the result is not as specifie ...