Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE STEERING RACK BOOT CLIP (for LH Side)

(a) Using pliers, remove the steering rack boot clip.

2. REMOVE STEERING RACK BOOT CLIP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

3. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for LH Side)

(a) Using a screwdriver, remove the No. 2 steering rack boot clamp.

NOTICE:

Be careful not to damage the No. 2 steering rack boot.

4. REMOVE NO. 2 STEERING RACK BOOT CLAMP (for RH Side)

HINT:

Perform the same procedure as for the LH side.

5. REMOVE NO. 2 STEERING RACK BOOT

6. REMOVE NO. 1 STEERING RACK BOOT

    Components
    COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 NO. 2 ENGINE UNDER COVER *2 STEERING INTERMEDIATE SHAFT ASSEMBLY *3 TIE ROD ASSEMBLY LH *4 COTTER PIN T ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH (a) Secure the tie rod assembly LH in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Install the nut to the ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Hazard Warning Switch: Inspection
    INSPECTION PROCEDURE 1. INSPECT HAZARD WARNING SWITCH (RADIO RECEIVER ASSEMBLY) (a) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Hazard Warning Signal Switch (Radio Receiver Assembly)) - - Standard Resistance: Tester Co ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Spiral Cable: Inspection
    INSPECTION PROCEDURE 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY NOTICE: Do not remove the steering sensor from the spiral cable sub-assembly when inspecting the spiral cable sub-assembly. Remove the steering sensor from the spiral cable sub-assembly only when replacing the spiral cable sub-assembly. ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0112