CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | INSPECT BATTERY VOLTAGE |
(a) Turn the engine switch off.
(b) Measure the voltage of the battery.
Standard Voltage:
11 to 14 V
HINT:
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
| 3. | CHECK DTC AND FREEZE FRAME DATA* |
HINT:
Refer to DTC Check / Clear.
Click here
|
| 4. | PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
|---|---|
| Symptom does not occur. | A |
| Symptom occurs. | B |
| B | | GO TO STEP 6 |
|
| 5. | SYMPTOM SIMULATION |
|
| 6. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
HINT:
| B | | PROCEED TO CAN COMMUNICATION SYSTEM |
|
| 7. | CHECK FOR DTC* |
(a) Check for DTCs.
Click here
HINT:
Refer to Diagnostic Trouble Code Chart when any DTCs are output.
Click here
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
| B | | GO TO STEP 10 |
|
| 8. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. | B |
| B | | GO TO STEP 10 |
|
| 9. | OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Refer to Terminals of ECU.
Click here
(b) Refer to Data List / Active Test.
Click here
|
| 10. | REPAIR OR REPLACE |
|
| 11. | CONFIRMATION TEST |
| NEXT | | END |
Freeze Frame Data
On-vehicle InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Cushion Heater (for 60/40 Split Seat Type Rh Side): Components
COMPONENTS ILLUSTRATION *A w/o Rear No. 2 Seat *B for Manual Seat *C for Power Seat - - *1 NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH *2 POWER SEAT SWITCH ASSEMBLY *3 REAR SEAT COVER CAP RH *4 SEAT HEATER ASSEMBLY *5 SEPARATE TYPE REAR SEAT CUSHION COVER ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: ECM Power Source Circuit
DESCRIPTION When the engine switch is turned on (IG), the battery voltage is applied to the IGSW terminal of the ECM. The output signal from the MREL terminal of the ECM causes a current to flow to the coil of the semiconductor pwr integration ECU (EFI-MAIN relay), closing the contacts and supplying ...