ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK STEERING EFFORT (TORQUE)
NOTICE:
These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.
Click here
(a) Stop the vehicle on a level, paved surface and align the wheels straight ahead.
(b) Remove the horn button assembly.
Click here
(c) Connect the cable to the negative (-) battery terminal.
(d) Using a torque wrench, check that the steering wheel assembly set nut is properly tightened.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(e) Start the engine so that the power steering is ready to operate.
(f) Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method.
Standard Steering Effort (Reference):
6.9 N*m (70 kgf*cm, 61 in.*lbf) or less
(g) Align the front wheels facing straight ahead.
(h) Turn the engine switch off.
(i) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
(j) Install the horn button assembly.
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Audio And Visual System (for 8 Inch Display): Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG) and wait for 90 seconds. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. Body Electrical > Navigation Sys ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Air Conditioning System: Evaporator Temperature Circuit (B1417/17)
DESCRIPTION The No. 2 air conditioning harness assembly is installed on the evaporator in the rear air conditioner unit to detect the temperature of the cooled air that has passed through the evaporator, which is used to control the air conditioning system. It sends signals to the air conditioning a ...