Inspection
INSPECTION
PROCEDURE
1. INSPECT TILT AND TELESCOPIC SWITCH
| (a) Remove the tilt and telescopic switch. Click here |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (VC) - 3 (MSW) | Tilt up | 342 to 378 Ω |
| Tilt down | 1890.5 to 2089.5 Ω | |
| Telescopic contract | 750.5 to 829.5 Ω | |
| Telescopic extend | 152 to 168 Ω |
Installation
INSTALLATION
PROCEDURE
1. INSTALL TILT AND TELESCOPIC SWITCH
(a) Engage the claw to install the tilt and telescopic switch.
(b) Connect the tilt and telescopic connector to the tilt and telescopic switch.
2. INSTALL LOWER STEERING COLUMN COVER
Click here
3. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Click here
Removal
REMOVAL
PROCEDURE
1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS
Click here
2. REMOVE LOWER STEERING COLUMN COVER
Click here
3. REMOVE TILT AND TELESCOPIC SWITCH
| (a) Disconnect the tilt and telescopic connector from the tilt and telescopic switch. |
|
(b) Disengage the claw and pull out the tilt and telescopic switch.
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Black Out Tape (for Front Door): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during black out tape removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/ ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Exhaust Manifold: Components
COMPONENTS ILLUSTRATION *A for TMC Made - - *1 NO. 2 ENGINE UNDER COVER *2 FRONT FLOOR COVER LH ILLUSTRATION *A for TMMC Made - - *1 NO. 2 ENGINE UNDER COVER *2 FRONT FLOOR COVER LH ILLUSTRATION *1 FRONT EXHAUST PIPE ASSEMBLY *2 NO. 1 EXHAUST P ...