REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front door opening trim weatherstrip removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative (-) battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here
HINT:
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
w/o Rear No. 2 Seat:
Click here
w/ Rear No. 2 Seat:
Click here
2. REMOVE INSTRUMENT PANEL GARNISH
Click here
3. REMOVE COWL SIDE TRIM BOARD
(a) Remove the clip.
| Place Hand Here |
| Remove in this Direction |
(b) Disengage the clip and claw to remove the cowl side trim board as shown in the illustration.
4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
| (a) Remove the front door opening trim weatherstrip. |
|
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor s ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > 2gr-fks (engine Control): Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT INJECTOR RELAY (INJ) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied between terminals 1 and ...