Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel lid opener motor assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative (-) battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
.png)
Click here .gif)
PROCEDURE
1. REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat)
Click here
2. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
Click here
3. REMOVE REAR NO. 3 FLOOR BOARD (w/o Rear No. 2 Seat)
Click here
4. REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)
Click here
5. REMOVE REAR NO. 4 FLOOR BOARD (w/o Rear No. 2 Seat)
Click here
6. REMOVE FRONT DECK FLOOR BOX (w/o Rear No. 2 Seat)
Click here
7. REMOVE DECK SIDE TRIM BOX RH (w/o Rear No. 2 Seat)
Click here
8. REMOVE REAR FLOOR FINISH PLATE (w/o Rear No. 2 Seat)
Click here
9. REMOVE REAR DOOR SCUFF PLATE LH (w/o Rear No. 2 Seat)
Click here
10. REMOVE REAR SEAT ASSEMBLY LH (w/o Rear No. 2 Seat)
Click here
11. REMOVE UPPER QUARTER TRIM PAD LH (w/o Rear No. 2 Seat)
Click here
12. REMOVE REAR SEAT SIDE GARNISH LH (w/o Rear No. 2 Seat)
Click here
13. REMOVE REAR FLOOR FINISH SIDE PLATE LH (w/o Rear No. 2 Seat)
Click here
14. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/o Rear No. 2 Seat)
Click here
15. REMOVE ROPE HOOK ASSEMBLY (w/o Rear No. 2 Seat)
Click here
16. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/o Rear No. 2 Seat)
Click here
17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/o Rear No. 2 Seat)
Click here
18. REMOVE FUEL PUMP CONTROL ECU ASSEMBLY (w/o Rear No. 2 Seat)
w/ Woofer:
Click here
19. REMOVE NO. 2 DECK BOARD REINFORCEMENT (w/o Rear No. 2 Seat)
w/ Woofer:
Click here
20. REMOVE REAR NO. 1 SPEAKER BRACKET (w/o Rear No. 2 Seat)
w/ Woofer:
Click here
21. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (w/o Rear No. 2 Seat)
w/ Woofer:
Click here
22. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)
Click here
23. REMOVE REAR DOOR SCUFF PLATE LH (w/ Rear No. 2 Seat)
Click here
24. REMOVE REAR DOOR INSIDE SCUFF PLATE LH (w/ Rear No. 2 Seat)
Click here
25. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH (w/ Rear No. 2 Seat)
for 60/40 Split Seat Type:
Click here
for Captain Seat Type:
Click here
26. REMOVE FRONT DECK SIDE TRIM COVER LH (w/ Rear No. 2 Seat)
Click here
27. REMOVE REAR SEAT SIDE GARNISH LH (w/ Rear No. 2 Seat)
Click here
28. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (w/ Rear No. 2 Seat)
for LH Side:
Click here
29. REMOVE ROPE HOOK ASSEMBLY (w/ Rear No. 2 Seat)
for LH Side:
Click here
30. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Rear No. 2 Seat)
for LH Side:
Click here
31. REMOVE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY (w/ Rear No. 2 Seat)
Click here
32. REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (w/ Rear No. 2 Seat)
Click here
33. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (w/ Rear No. 2 Seat)
Click here
34. REMOVE FUEL LID LOCK WITH MOTOR ASSEMBLY
| (a) Disengage the clamp. |
|
(b) Disengage the claw.
(c) Disconnect the connector to remove the fuel lid lock with motor assembly.
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL LID LOCK WITH MOTOR ASSEMBLY (a) Engage the clamp. (b) Engage the claw to install the fuel lid lock with motor assembly. (c) Connect the connector. 2. INSTALL RE ...
Other materials:
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Valve Body Assembly: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MANUAL VALVE (a) Remove the manual valve from the transmission valve body assembly. (b) Remove the E-ring and separate the manual valve connecting rod from the manual valve. *1 Manual Valve Connecting Rod *2 Manual Valve *3 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Light Sensor Circuit (B1244)
DESCRIPTION The automatic light control sensor detects ambient light. The sensor creates an electrical signal based on the amount of light detected, and sends the signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) turns on or off the headlights a ...
Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual
- For your information
- Pictorial index
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Lexus Display Audio system
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual
0.01