INSPECTION
PROCEDURE
1. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
(a) Apply 6.0 V (4 dry cell batteries in series) to the rear door outside handle assembly LH and check that the light comes on. NOTICE: Do not apply more than 6.0 V. OK:
If the result is not as specified, replace the rear door outside handle assembly LH. |
|
2. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY RH
(a) Apply 6.0 V (4 dry cell batteries in series) to the rear door outside handle assembly RH and check that the light comes on. NOTICE: Do not apply more than 6.0 V. OK:
If the result is not as specified, replace the rear door outside handle assembly RH. |
|
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Roof Antenna: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone antenna assembly removal/installation are shown below. Necessary Procedures After Parts Remov ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Airbag System: Short in P Squib (Dual Stage - 2nd Step) Circuit (B1815-B1818)
DESCRIPTION The front passenger squib 2nd step circuit consists of the airbag sensor assembly and instrument panel passenger airbag assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in ...