ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front seat outer belt assembly.
PROCEDURE
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the front seat outer belt assembly installed to the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the front seat outer belt assembly with a new one.
2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the front seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the front seat outer belt assembly with a new one.
Precaution
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Gear: Installation
INSTALLATION PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH (a) Install the lock nut and tie rod assembly LH to the steering gear assembly until the matchmarks are aligned. HINT: After adjusting the toe-in, tighten the lock nut. *a Matchmark 2. INSTALL TIE ROD ASSEMBLY RH HINT: ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Differential Oil Seal (for Lh Side): Components
COMPONENTS ILLUSTRATION *1 FRONT WHEEL OPENING EXTENSION PAD LH *2 NO. 3 ENGINE UNDER COVER *3 FRONT FENDER APRON SEAL LH - - ILLUSTRATION *1 FRONT DRIVE SHAFT OIL SEAL LH *2 O-RING *3 REFILL PLUG *4 OVERFLOW PLUG *5 DRAIN PLUG *6 GASKET Ti ...