INSTALLATION
PROCEDURE
1. INSTALL AUTOMATIC HIGH BEAM MAIN SWITCH ASSEMBLY (INTEGRATION CONTROL AND PANEL ASSEMBLY)
(a) Engage the 4 claws to install the automatic high beam main switch assembly (integration control and panel assembly) as shown in the illustration.
| Install in this Direction |
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL COWL SIDE TRIM BOARD LH
Click here
6. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
7. INSTALL INSTRUMENT PANEL GARNISH LH
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fuel Injector (for Direct Injection): Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL INJECTOR ASSEMBLY NOTICE: This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked. (a) Measure the resistance according ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Radar Sensor System: Terminals Of Ecu
TERMINALS OF ECU CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply excessive force to the forward recognition ...