Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Vehicle Exterior / Lighting (ext) / Rear Combination Light Assembly (w/o Rear No. 2 Seat) / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH

(a) Apply battery voltage to the rear combination light assembly LH and check that the lights come on.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 1 (B)

Battery negative (-) → Terminal 3 (E)

Taillight comes on

Battery positive (+) → Terminal 2 (STP)

Battery negative (-) → Terminal 3 (E)

Stop light comes on

Battery positive (+) → Terminal 4 (TRN)

Battery negative (-) → Terminal 3 (E)

Turn signal light comes on*1

Battery positive (+) → Terminal 4 (TRN1) and 6 (TRN2)

Battery negative (-) → Terminal 3 (E)

Turn signal light comes on*2
  • *1: for Turn Signal Light Bulb Type
  • *2: for Turn Signal Light LED Type

If the result is not as specified, replace the rear combination light assembly LH.

*a

Component without harness connected

(Rear Combination Light Assembly LH)

2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH

(a) Apply battery voltage to the rear combination light assembly RH and check that the lights come on.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 1 (B)

Battery negative (-) → Terminal 3 (E)

Taillight comes on

Battery positive (+) → Terminal 2 (STP)

Battery negative (-) → Terminal 3 (E)

Stop light comes on

Battery positive (+) → Terminal 4 (TRN1)

Battery negative (-) → Terminal 3 (E)

Turn signal light comes on*1

Battery positive (+) → Terminal 4 (TRN1) and 6 (TRN2)

Battery negative (-) → Terminal 3 (E)

Turn signal light comes on*2
  • *1: for Turn Signal Light Bulb Type
  • *2: for Turn Signal Light LED Type

If the result is not as specified, replace the rear combination light assembly RH.

*a

Component without harness connected

(Rear Combination Light Assembly RH)
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear ...

    Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT LENS AND BO ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Washer Nozzle(for Front Side): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (a) Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield. Standard: Center of washer fluid contacts the windshield in the areas shown in the illustration. *a Upper Li ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad Switch: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below. Necessary Procedure After Parts Rem ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0147