REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
2. REMOVE REAR LIGHT ASSEMBLY (for Bulb Type Turn Signal Light)
| (a) Disconnect the connector. |
|
(b) Remove the 3 nuts.
(c) Disengage the pin to remove the rear light assembly as shown in the illustration.
| Remove in this Direction |
3. REMOVE REAR LIGHT ASSEMBLY (for LED Type Turn Signal Light)
| (a) Disconnect the connector. |
|
(b) Remove the 3 nuts.
(c) Disengage the pin to remove the rear light assembly as shown in the illustration.
| Remove in this Direction |
Components
DisassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Check Bus 3 Line for Short to +B
DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when there is no resistance between terminal 6 (CA3H) of the network gateway ECU and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the network gateway ECU and terminal 16 (BAT) of the DLC3. Symptom Troubl ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Zero Point Calibration of Steering Angle Sensor Not Acquired (X20D8)
DESCRIPTION Code Tester Display Measurement Item Trouble Area X20D8 Zero Point Calibration of Steering Angle Sensor Not Acquired History of being unable to obtain the steering angle zero point
Sensor installation
Yaw rate and acceleration sensor (airbag sensor assembly)*1
Y ...