Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Precaution

NOTICE:

• After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.
• When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

  System Name	See Procedure
  Lane Control System
  Intelligent Clearance Sonar System
  Parking Assist Monitor System
  Panoramic View Monitor System
  Lighting System (w/ Automatic Headlight Beam Level Control System)
  Power Door Lock Control System
  Power Back Door System (w/ Outside Door Control Switch)

• Radio receiver assembly*1
• DCM (telematics transceiver)*2

• *1: After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).

  *2: w/ Manual (SOS) Switch

Audio And Visual System (for 8 Inch Display)

...

Parts Location

PARTS LOCATION ILLUSTRATION *1 TELEPHONE MICROPHONE ASSEMBLY *2 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-IG2 NO. 3 FUSE (w/ Manual (SOS) Switch) - DCM FUSE (w/ Manual (SOS) Switch) - E ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Lock System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Steering Lock System DTC No. Detection Item DTC Detection Condition Note Link B2781 Open / Short in Steering Lock ECU One of the following conditions is met (1-trip detection logic (Only output while a malfunction is present and the engine switch is o ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
DESCRIPTION The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT: A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at ...