INSTALLATION
PROCEDURE
1. INSTALL TOWING CONVERTER RELAY
(a) Engage the guide.
(b) Install the towing converter relay with the bolt.
(c) Connect the connector.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
3. INSTALL RECLINING REMOTE CONTROL BEZEL RH (w/o Rear Power Seat System)
Click here
4. INSTALL FOLD SEAT SWITCH ASSEMBLY (w/ Rear Power Seat System)
Click here
5. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
6. INSTALL ROPE HOOK ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
8. INSTALL REAR FLOOR FINISH SIDE PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
9. INSTALL REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
Click here
10. INSTALL UPPER QUARTER TRIM PAD RH
HINT:
Use the same procedure as for the LH side.
Click here
11. INSTALL REAR SEAT ASSEMBLY RH
Click here
12. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
13. INSTALL REAR FLOOR FINISH PLATE
Click here
14. INSTALL DECK SIDE TRIM BOX RH
Click here
15. INSTALL REAR NO. 4 FLOOR BOARD
Click here
16. INSTALL REAR DECK FLOOR BOX
Click here
17. INSTALL REAR NO. 3 FLOOR BOARD
Click here
18. INSTALL DECK BOARD ASSEMBLY
Click here
19. INSTALL TONNEAU COVER ASSEMBLY
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Zero Point Calibration of Steering Angle Sensor Malfunction (X20D7)
DESCRIPTION Code Tester Display Measurement Item Trouble Area X20D7 Zero Point Calibration of Steering Angle Sensor Malfunction History of the steering angle sensor zero point calibration position differing from the stored value
Poor adjustment of the center position of the ste ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seatback Heater (for 60/40 Split Seat Type Rh Side): Inspection
INSPECTION PROCEDURE 1. INSPECT SEAT HEATER ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 Seat heater temperature 20 °C (68 °F) 3.98 to 4.78 Ω If the result is not ...