COMPONENTS
ILLUSTRATION
| *1 | DECK BOARD ASSEMBLY | *2 | TONNEAU COVER ASSEMBLY |
ILLUSTRATION
| *A | for TMC Made | *B | for TMMC Made |
| *1 | DECK SIDE TRIM BOX RH | *2 | FRONT DECK FLOOR BOX |
| *3 | REAR DECK FLOOR BOX | *4 | REAR FLOOR FINISH PLATE |
| *5 | REAR NO. 3 FLOOR BOARD | *6 | REAR NO. 4 FLOOR BOARD |
ILLUSTRATION
| *1 | DECK TRIM SIDE PANEL ASSEMBLY LH | *2 | NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY |
| *3 | NO. 1 LUGGAGE COMPARTMENT TRIM HOOK | *4 | REAR DOOR SCUFF PLATE LH |
| *5 | REAR FLOOR FINISH SIDE PLATE LH | *6 | REAR SEAT SIDE GARNISH LH |
| *7 | ROOF SIDE INNER GARNISH ASSEMBLY LH | *8 | ROPE HOOK ASSEMBLY |
| *9 | UPPER QUARTER TRIM PAD LH | *10 | CLIP |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *1 | QUARTER WINDOW ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
InstallationLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > 4wd Control Ecu: Installation
INSTALLATION PROCEDURE 1. PRECAUTION NOTICE: When 4WD ECU assembly is replaced with a known good one from another vehicle, it is necessary to perform calibration. Click here 2. INSTALL 4WD ECU ASSEMBLY (a) Install the 4WD ECU assembly with the bolt. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Blind Spot Monitor System: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis ...