SYSTEM DESCRIPTION
GENERAL
The rear window defogger wire (back window glass) is attached to the inside of the rear window and defogs the window surface quickly when the rear window defogger switch is pressed. The indicator light on the switch illuminates while the system is operating. This system automatically turns off after approximately 15 minutes.
NOTICE:
If the battery voltage is low, the window defogger system may not operate. When "Operation of Electrical Items Restricted." is not displayed on the multi-information display in the combination meter assembly, check the Data List item "Battery Control Count (Body ECU)".
Click here
HINT:
FUNCTION OF MAIN COMPONENT
| Component | Outline |
|---|---|
| Radio Receiver Assembly | Sends signals to the air conditioning amplifier assembly to operate the window defogger system. |
| Air Conditioning Amplifier Assembly | Sends a window defogger system activation request signal to the semiconductor pwr integration ECU. |
| Semiconductor Pwr Integration ECU | Receives a window defogger system activation request signal from the air conditioning amplifier assembly and supplies power to the rear window defogger wire (back window glass). |
| Rear Window Defogger Wire (Back Window Glass) | Receives power from the semiconductor pwr integration ECU and heats the rear window using the rear window defogger wire (back window glass). |
System Diagram
How To Proceed With TroubleshootingLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Throttle/Pedal Position Sensor "A" Minimum Stop Performance (P210900)
DESCRIPTION The idle speed is controlled by the Electronic Throttle Control System (ETCS). The ETCS is comprised of a throttle actuator, which operates the throttle valve, and a throttle position sensor, which detects the opening amount of the throttle valve. The ECM controls the throttle actuator t ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof Housing (for Slidng Roof): Reassembly
REASSEMBLY PROCEDURE 1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY (a) Hold down the roof wind deflector panel sub-assembly. Hold Position (b) Using a screwdriver, slide the sliding roof drive cable LH as shown in the illustration to install it. *a Protective Tape Push Posi ...