REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner motor and pump assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic view monitor system | |
| Front bumper assembly (w/ Intelligent clearance sonar system) |
|
| |
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
2. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY
(a) Loosen the clip and remove the headlight cleaner hose as shown in the illustration.
| Remove in this Direction |
(b) Disconnect the connector.
| Remove in this Direction |
(c) Remove the headlight cleaner motor and pump assembly as shown in the illustration.
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intelligent Clearance Sonar System: System Description
SYSTEM DESCRIPTION CASES OF UNNECESSARY INTELLIGENT CLEARANCE SONAR SYSTEM OPERATION (a) In the following situations, the intelligent clearance sonar system may operate even when there is no possibility of a collision: (1) Environmental influence
There is an obstacle on the shoulder of the road ( ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Parking Assist Monitor System: Steering Angle Sensor Failure (C1626)
DESCRIPTION This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area C1626 Steering Angle Sensor Failure A fail flag ...