Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT WHEEL RH

Click here

2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click here

3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Click here

4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Click here

5. DRAIN WASHER FLUID

Click here

6. REMOVE LEVEL WARNING SWITCH ASSEMBLY

(a) Disconnect the connector.

Remove in this Direction

(b) Remove the level warning switch assembly as shown in the illustration.

    Components
    COMPONENTS ILLUSTRATION *A for TMMC Made - - *1 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH *2 FRONT WHEEL OPENING EXTENSION PAD RH *3 LEVEL WARNING SWITCH ASSEMBLY - - ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY HINT: This check should be performed with the level warning switch assembly installed on the washer jar. (a) Fill the washer jar with w ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Vehicle Stability Control System: Brake Actuator Operation Sound is Loud during Initial Check
    CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform "Calibration". Click here PROCEDURE 1. PERFORM ROAD TEST (a) After turning the engine switch on (IG), compare the operating sound of the brake actuator the first time the vehicle speed ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Can Communication System: Dtc Combination Table
    DTC COMBINATION TABLE HOW TO INTERPRET COMMUNICATION DTCS (DTCS THAT START WITH U) (a) If a CAN communication error cannot be reproduced, determine the suspected malfunctioning part using the DTCs stored in ECUs that are connected to the CAN buses by following the procedure below. HINT: Communicatio ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.0155