Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Vehicle Exterior / Wiper / Washer / Washer Level Warning Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:

This check should be performed with the level warning switch assembly installed on the washer jar.

(a) Fill the washer jar with washer fluid.

*a

Component without harness connected

(Level Warning Switch Assembly)

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (S) - 2 (E)

Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher*

10 kΩ or higher

Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower*

Below 1 Ω

HINT:

*: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.

If the result is not as specified, replace the level warning switch assembly.

    Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL RH Click here 2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH HINT: Use the same procedure as for the LH side. Click here 3. REMOVE FRONT WHEEL OPENING EXTE ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL LEVEL WARNING SWITCH ASSEMBLY (a) Install the level warning switch assembly as shown in the illustration. *a Protrusion *b Marking Install in this ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Vehicle Speed Sensor (C1A45)
    DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area C1A45 Vehicle Speed Sensor A fail flag is transmitted from the skid control ECU Vehicle stabilit ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Window Control System: Terminals Of Ecu
    TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the N7 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0128