INSPECTION
PROCEDURE
1. INSPECT WASHER MOTOR AND PUMP ASSEMBLY
| (a) for Front Washer: (1) Remove the washer jar. (2) Disconnect the washer motor and pump assembly connector. HINT: This check should be performed with the washer motor and pump assembly installed on the washer jar. (3) Fill the washer jar with washer fluid. (4) Connect a battery positive (+) lead to terminal 1 of the washer motor and pump assembly, and a negative (-) lead to terminal 2. (5) Check that washer fluid flows from the washer jar. OK: Washer fluid flows from the washer jar. If the result is not as specified, replace the washer motor and pump assembly. |
|
| (b) for Rear Washer: (1) Remove the washer jar. (2) Disconnect the washer motor and pump assembly connector. HINT: This check should be performed with the washer motor and pump assembly installed on the washer jar. (3) Fill the washer jar with washer fluid. (4) Connect a battery positive (+) lead to terminal 2 of the washer motor and pump assembly, and a negative (-) lead to terminal 1. (5) Check that washer fluid flows from the washer jar. OK: Washer fluid flows from the washer jar. If the result is not as specified, replace the washer motor and pump assembly. |
|
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Power Seat Control System (w/ Memory): Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (DRIVER DOOR) *2 FRONT SEAT OUTER BELT ASSEMBLY LH *3 SEAT MEMORY SWITCH LH *4 OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) *5 ECM *6 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY - DOOR CONTROL SWIT ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Safety Connect System: Red Indicator Remains On
DESCRIPTION This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code. PROCEDURE 1. CHECK DTC (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the e ...