On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PTC HEATER RELAY
(a) Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (PTC HTR NO. 1) | *b | Component without harness connected (PTC HTR NO. 2) |
| *c | Component without harness connected (PTC HTR NO. 3) | - | - |
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Battery voltage applied between terminals 1 and 2 | Below 1 Ω |
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Combination Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH ASSEMBLY (a) Inspect the NORMAL or NORMAL CUSTOMIZE mode switch: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 8 (B) - 1 (GND) Combinati ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Solar Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during solar sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep ...