REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during room temperature sensor removal/installation are shown below.
Necessary Procedures after parts removed/installed/replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
6. REMOVE LOWER INSTRUMENT FINISH PANEL SUB
Click here
7. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR
| Remove in this Direction |
(a) Disengage the 2 claws as shown in the illustration.
| (b) Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor. |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. The sound signal that has been sent is amplified by the stereo component amplifier assembly and then is sent to the speakers. If there is an open or shor ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Wiper Motor: Inspection
INSPECTION PROCEDURE 1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY (a) Check the wiper intermittent operation. (1) Connect a battery positive (+) lead to terminal 4 (+B) and a negative (-) lead to terminal 2 (C1) and terminal 5 (E), and check that the motor operates. OK: Motor operates. If th ...