INSPECTION
PROCEDURE
1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY
| (a) Check the wiper intermittent operation. (1) Connect a battery positive (+) lead to terminal 4 (+B) and a negative (-) lead to terminal 2 (C1) and terminal 5 (E), and check that the motor operates. OK: Motor operates. If the result is not as specified, replace the rear wiper motor and bracket assembly. |
|
(b) Check the wiper continuous operation.
(1) Connect a battery positive (+) lead to terminal 4 (+B) and a negative (-) lead to terminal 3 (LS) and terminal 5 (E), and check that the motor operates.
OK:
Motor operates.
If the result is not as specified, replace the rear wiper motor and bracket assembly.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/o Memory): Terminals Of Ecu
TERMINALS OF ECU CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) (a) Disconnect the N4 outer mirror control ECU assembly (driver door) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the con ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Meter / Gauge System: Fuel Sender Open Detected (B1500)
DESCRIPTION This DTC is stored when the combination meter assembly detects a fuel sender gauge assembly malfunction via a direct line. DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note B1500 Fuel Sender Open Detected When IG voltage is 9.5 V or more and the ...