INSTALLATION
PROCEDURE
1. INSTALL COMBINATION METER ASSEMBLY
(a) Connect each connector.
(b) Engage the clamp.
(c) Install the combination meter assembly with the 4 screws.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
(a) Connect the connector.
(b) Engage the 7 clips as shown in the illustration.
| Install in this Direction |
(c) Engage the 4 clips and 2 claws to install the instrument cluster finish panel sub-assembly.
3. INSTALL LOWER INSTRUMENT FINISH PANEL SUB
Click here
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
5. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
6. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
8. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
10. INSTALL COWL SIDE TRIM BOARD LH
Click here
11. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
12. INSTALL INSTRUMENT PANEL GARNISH LH
Click here
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
14. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Click here
Reassembly
Headup DisplayLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Throttle Actuator "A" Control Motor Circuit Current Below Threshold (P210018,P210019)
DESCRIPTION The throttle actuator is operated by the ECM and opens and closes the throttle valve using gears. The opening angle of the throttle valve is detected by the throttle position sensor, which is mounted on the throttle body with motor assembly. The throttle position sensor provides feedback ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting (ext): Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT H-LP LH RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Voltage not applied between terminals 1 and 2 10 kΩ or ...