FREEZE FRAME DATA
FREEZE FRAME DATA
(a) Whenever a meter DTC is detected, the headup display (meter mirror sub-assembly) stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Head Up Display / Trouble Codes.
(e) According to the Techstream display, select a DTC that stored freeze frame data.
(f) Read the freeze frame data recorded when the DTC was stored.
Head Up Display| Tester Display | Condition | Displayed Item |
|---|---|---|
| B1321 | Lost Communication with EMV |
|
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0142 | Lost Communication with Body Control Module "B" | |
| U023A | Lost Communication with Front Camera Module |
NOTICE:
Clearing the DTCs will also clear the freeze frame data.
CLEAR FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Clear DTCs and freeze frame data.
Click here
Data List / Active Test
Diagnostic Trouble Code ChartLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Occupant Classification Ecu: Installation
INSTALLATION PROCEDURE 1. INSTALL OCCUPANT DETECTION ECU (a) Engage the claw to install the occupant detection ECU. NOTICE: If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one. ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Instrument Panel Safety Pad: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during instrument panel safety pad removal/installation are shown below. Necessary Procedures After Parts Remov ...