FREEZE FRAME DATA
FREEZE FRAME DATA
(a) Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
(e) According to the Techstream display, select a DTC that stored freeze frame data.
(f) Read the freeze frame data recorded when the DTC was stored.
Combination Meter| Tester Display | Condition | Displayed Item |
|---|---|---|
| B1321 | Lost Communication with EMV |
|
| B1326 | Lost Communication with Clock Device (Local-CAN) | |
| B1507 | Open in Turn Signal Circuit | |
| B1508 | Short in Turn Signal / Hazard Flasher Circuit | |
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0129 | Lost Communication with Brake System Control Module | |
| U0131 | Lost Communication with Power Steering Control Module | |
| U0140 | Lost Communication with Body Control Module | |
| U0151 | Lost Communication with Restraints Control Module | |
| U0163 | Lost Communication with Navigation Control Module | |
| U0182* | Lost Communication with Lighting Control Module Front | |
| U023A | Lost Communication with Front Camera Module |
CLEAR FREEZE FRAME DATA
NOTICE:
Clearing the DTCs will also clear the freeze frame data.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Clear DTCs and freeze frame data.
Click here
Dtc Check / Clear
Data List / Active TestLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Internal Control Module EEPROM Data Memory Failure (P062F44)
DESCRIPTION The ECM monitors its internal operation and will store this DTC when it detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P062F44 Internal Control Module EEPROM Data Memory Failure ECM internal malfunction ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Glove Box Light: Installation
INSTALLATION PROCEDURE 1. INSTALL GLOVE BOX LIGHT ASSEMBLY (a) Turn the glove box light assembly as shown in the illustration to install it. Install in this Direction 2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Click here 3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Click here ...