DIAGNOSTIC TROUBLE CODE CHART
Meter / Gauge System DTC No. | Detection Item | Memory | Note | Link |
---|---|---|---|---|
B1321 | Lost Communication with EMV | DTC stored | - |
|
B1326 | Lost Communication with Clock Device (Local-CAN) | DTC stored | - |
|
B1500 | Fuel Sender Open Detected | - | - |
|
B1507 | Open in Turn Signal Circuit | DTC stored | - |
|
B1508 | Short in Turn Signal / Hazard Flasher Circuit | DTC stored | - |
|
U0100 | Lost Communication with ECM / PCM "A" | DTC stored | - |
|
U0129 | Lost Communication with Brake System Control Module | DTC stored | - |
|
U0131 | Lost Communication with Power Steering Control Module | DTC stored | - |
|
U0140 | Lost Communication with Body Control Module | DTC stored | - |
|
U0151 | Lost Communication with Restraints Control Module | DTC stored | - |
|
U0163 | Lost Communication with Navigation Control Module | DTC stored | - |
|
U0182 | Lost Communication with Lighting Control Module Front | DTC stored | w/ Automatic Headlight Beam Level Control System |
|
U023A | Lost Communication with Front Camera Module | DTC stored | - |
|
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Vehicle Stability Control System: Brake Warning Light does not Come ON
DESCRIPTION The skid control ECU (brake actuator assembly) controls the brake warning light in the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform "Calibration". Click here PROCEDURE 1. ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Ultrasonic Sensor (for Front): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...