INSPECTION
PROCEDURE
1. INSPECT INNER REAR VIEW MIRROR ASSEMBLY
(a) Inspect the operation of the electrochromic inner rear view mirror assembly.
| *a | Black Colored Tape | *b | Forward Sensor |
| *c | Bright | *d | Dark |
| *e | Battery | *f | EC Switch |
| *g | Component without harness connected (Inner Rear View Mirror Assembly) | - | - |
(1) Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2.
(2) Press the EC switch.
(3) Attach black colored tape to the forward sensor to prevent it from sensing.
(4) Light up the mirror with an electric light, and check that the mirror surface changes from bright to dark.
OK:
Mirror surface changes from bright to dark.
(5) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 - 5 | Inner rear view mirror surface Bright → Dark | Below 1 V → 1.35 V |
If the result is not as specified, replace the inner rear view mirror assembly.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fuel Injector (for Port Injection): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel injector assembly removal/installation are shown below. Necessary Procedures After Parts Removed/In ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Ambient Light(for Front Door): Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 DOOR ARMREST COVER *3 FRONT DOOR INSIDE HANDLE BEZEL PLUG *4 FRONT DOOR NO. 1 STIFFENER CUSHION *5 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *6 MULTIPLEX NETWORK MAST ...