Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE

1.

START DIAGNOSTIC MODE

(a) Activate diagnostic mode and check if the "Service Menu" screen can be displayed.

Click here

OK:

Diagnostic mode can be activated.

NG

GO TO STEP 3

OK

2.

CHECK PANEL SWITCH (OPERATION CHECK)

(a) Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.

Click here

(b) Operate the abnormal switch and check if the switch status is correctly displayed.

OK:

The switch status is correctly displayed as operated.

OK

REPLACE RADIO RECEIVER ASSEMBLY

NG

GO TO STEP 3

3.

REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK (SWITCH OPERATION CHECK)

(a) Enter self-diagnostic mode.

Click here

(b) Operate the remote touch screen in the upper left to turn the switch illumination off.

NOTICE:

Since the remote touch screen may recognize a pinch in/out operation if operated with 2 fingers, always use 1 finger to operate the remote touch screen in self-diagnostic mode.

*a

Switch Illumination

(c) With the switch illumination turned off, press each switch of the remote touch (remote operation controller assembly) and check that the switch illumination turns on.

Result

Proceed to

Self check mode cannot be activated.

A

Some switches do not turn on the switch illumination when they are pressed.

All switches turn on the switch illumination when they are pressed.

B

A

REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY)

B

REPLACE RADIO RECEIVER ASSEMBLY

    Switch Lights of Remote Touch Always Illuminate or cannot be Controlled Using Rheostat
    DESCRIPTION Power is supplied to the remote touch (remote operation controller assembly) illumination when the light control switch is in the tail or head position. HINT: When the remote touch (rem ...

    Pointer Displayed/not Displayed Repeatedly
    WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be need ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Oil Pan And Oil Level Sensor: Installation
    INSTALLATION PROCEDURE 1. INSTALL ENGINE OIL LEVEL SENSOR (a) Install the engine oil level sensor with the 2 bolts. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (b) Install a new clip to the engine oil level sensor. (c) Connect the engine oil level sensor connector. 2. INSTALL OIL STRAINER SUB-ASSEMBLY ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Automatic Transaxle System: Monitor Drive Pattern
    MONITOR DRIVE PATTERN MONITOR DRIVE PATTERN FOR ECT CAUTION: Perform the following procedure on a level surface while strictly observing all traffic laws and speed limits. HINT: Performing this drive pattern is one method to simulate ECM (ECT) malfunction detection conditions. Some DTCs may not be d ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.0157