Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Precaution

NOTICE:

• When operating a rear No. 2 power seat, make sure that the area around the seat is free of obstructions.
• When operating a rear No. 2 power seat, be careful not to allow any body parts or foreign objects to interfere with the seat or other components as it may result in injuries or damage.
• When operating a rear No. 2 power seat using the fold seat switch assembly or No. 1 fold seat switch assembly, if something becomes jammed between the seat cushion and seatback, the rear No. 2 power seat operation will stop and a buzzer will sound.
• If a fold seat control ECU (RH/LH seat) has been replaced, initialization must be performed.
• When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

  System Name	See Procedure
  Lane Control System
  Pre-collision System
  Intelligent Clearance Sonar System
  Parking Assist Monitor System
  Panoramic View Monitor System
  Lighting System (w/ Automatic Headlight Beam Level Control System)
  Power Door Lock Control System
  Power Back Door System (w/ Outside Door Control Switch)

Rear Power Seat Control System(for Third Row)

...

Parts Location

PARTS LOCATION ILLUSTRATION *1 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - P/SEAT R/R FUSE - P/SEAT R/L FUSE *2 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-DCC NO. 2 FUSE - ECU- ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Safety Connect System: Dcm Activation
DCM ACTIVATION HINT: If the DCM (telematics transceiver) has been replaced, it is necessary to perform the Register Vehicle Information procedure. DCM ACTIVATION (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Choose "Telematics" from the S ...

Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Audio And Visual System (for 8 Inch Display): Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) (a) Disconnect the J148 ...