INSPECTION
PROCEDURE
1. PRECAUTION
NOTICE:
After performing the following check, initialize the fold seat control ECU (initial position reset and initial position memorization).
Click here
2. INSPECT REAR SEATBACK FRAME SUB-ASSEMBLY LH
(a) Check the operation of the reclining motor.
(1) Apply battery voltage to the reclining motor connector, and check that the rear seatback frame sub-assembly LH operates smoothly as follows.
NOTICE:
| *1 | Fold Motor | *2 | Reclining Motor |
| *a | Forward | *b | Backward |
| *c | Component without wire harness connected (Rear Seatback Frame sub-assembly LH) | - | - |
OK:
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal y1-3 (FWD) Battery negative (-) → Terminal y1-4 (BACK) | Forward |
| Battery positive (+) → Terminal y2-1 Battery negative (-) → Terminal y2-2 | |
| Battery positive (+) → Terminal y1-4 (BACK) Battery negative (-) → Terminal y1-3 (FWD) | Backward |
| Battery positive (+) → Terminal y2-2 Battery negative (-) → Terminal y2-1 |
If the result is not as specified, replace the rear seatback frame sub-assembly LH.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Meter / Gauge System: Tachometer Malfunction
DESCRIPTION In this circuit, the combination meter assembly receives engine speed signals from the ECM via CAN communication. The combination meter assembly displays the engine speed calculated based on the data received from the ECM. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When replacing ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad Switch: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below. Necessary Procedure After Parts Rem ...