INSTALLATION
PROCEDURE
1. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH
(a) Engage the guide.
(b) Install the 3 bolts.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
(c) Engage the 5 clamps to install the reclining remote control lever sub-assembly RH.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
3. INSTALL RECLINING REMOTE CONTROL BEZEL RH
Click here
4. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
5. INSTALL ROPE HOOK ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
HINT:
Use the same procedure as for the LH side.
Click here
7. INSTALL REAR FLOOR FINISH SIDE PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
8. INSTALL REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
Click here
9. INSTALL UPPER QUARTER TRIM PAD RH
HINT:
Use the same procedure as for the LH side.
Click here
10. INSTALL REAR SEAT ASSEMBLY RH
Click here
11. INSTALL REAR SEAT ASSEMBLY LH
Click here
12. INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
13. INSTALL REAR FLOOR FINISH PLATE
Click here
14. INSTALL DECK SIDE TRIM BOX RH
Click here
15. INSTALL FRONT DECK FLOOR BOX
Click here
16. INSTALL REAR NO. 4 FLOOR BOARD
Click here
17. INSTALL REAR DECK FLOOR BOX
Click here
18. INSTALL REAR NO. 3 FLOOR BOARD
Click here
19. INSTALL DECK BOARD ASSEMBLY
Click here
20. INSTALL TONNEAU COVER ASSEMBLY
Click here
ComponentsLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Seat Switch(for Rear Side): Inspection
INSPECTION PROCEDURE 1. INSPECT REAR POWER SEAT SWITCH LH (a) for LH Side: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 2 (FLDL) - 7 (E) FOLD switch pressed Below 100 Ω 2 (FLDL) - ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Cold Start Idle Control System Performance (P050A00)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC will be stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idle air control at cold start. When the eng ...