Components
COMPONENTS
ILLUSTRATION
| *1 | SEAT HEATER CONTROL SUB-ASSEMBLY | - | - |
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat heater control sub-assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System* | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here
2. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY
| (a) Disconnect the connector. |
|
(b) Disengage the clamp to remove the seat heater control sub-assembly.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
PROCEDURE
1. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY
| (a) Engage the clamp to install the seat heater control sub-assembly. |
|
(b) Connect the connector.
2. INSTALL FRONT SEAT ASSEMBLY
Click here
RelayLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Hood Support: Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF HOOD SUPPORT ASSEMBLY (a) Secure the hood support assembly horizontally in a vise with the piston rod pulled out. (b) Wearing safety glasses, gradually cut a part within the area (a) shown in the illustration using a metal saw to release the gas. Specification: ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Smart Access System With Push-button Start (for Entry Function): Additional Key cannot be Registered
DESCRIPTION If additional registration is not possible, a malfunction of the electrical key transmitter sub-assembly, certification ECU (smart key ECU assembly), engine switch, No. 2 indoor electrical key antenna assembly (front floor), steering lock ECU (steering lock actuator or upper bracket asse ...