INSPECTION
PROCEDURE
1. INSPECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the rear seat 3 point type belt assembly RH. |
|
2. INSPECT REAR SEAT INNER BELT ASSEMBLY LH
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the rear seat inner belt assembly LH. |
|
ComponentsLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Brake Actuator: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake actuator assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Inst ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Windshield Deicer System: Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY *A w/o Seat Heater System *B w/ Seat Heater System (a) Disconnect the J43 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the valu ...