ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear No. 1 seat outer belt assembly.
PROCEDURE
1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the rear No. 1 seat outer belt assembly installed to the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear No. 1 seat outer belt assembly with a new one.
2. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the rear No. 1 seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear No. 1 seat outer belt assembly with a new one.
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fuel Injector (for Port Injection): Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL INJECTOR ASSEMBLY HINT: Perform "Inspection After Repair" after replacing a fuel injector assembly. Click here (a) Apply a light coat of spindle oil or gasoline to 6 new O-rings, and install 1 to each fuel injector assembly. NOTICE: Check that there is no da ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wiper / Washer: Rain Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 RAIN SENSOR *2 RAIN SENSOR COVER *3 RAIN SENSOR TAPE - - On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Disconnect the U3 rain sensor connector. *a Front view of wire harness connector (to ...