CUSTOMIZE PARAMETERS
CUSTOMIZE SEAT BELT WARNING SYSTEM
NOTICE:
HINT:
The following items can be customized.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Warning.
(5) Select the setting by referring to the table below.
Warning| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Driver Side Seatbelt Warning Buzzer | Enables sounding of the driver seat belt warning buzzer | ON | 0:OFF,1:ON | Combination meter assembly |
| Front Passenger Side Seatbelt Warning Buzzer | Enables sounding of the front passenger seat belt warning buzzer | ON | 0:OFF,1:ON | Combination meter assembly |
| Rear Seatbelt Warning Buzzer | Enables sounding of the rear seat belt warning buzzer | ON | 0:OFF,1:ON | Combination meter assembly |
HINT:
These settings are only valid when the vehicle is driven at 20 km/h (12 mph) or more.
System Description
How To Proceed With TroubleshootingLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Back Door Control Switch: Components
COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 DOOR CONTROL SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY) *3 FRONT DOOR SCUFF PLATE LH *4 HOOD LOCK CONTROL LEVER SUB-ASSEMBLY *5 INSTRUMENT PANEL GARNISH LH *6 LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Occupant Classification Ecu: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the occupant detection ECU removal/installation are shown below. Necessary Procedure After Parts Removed/I ...