CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer to confirm the problem.
Click here
|
| 3. | PRE-CHECK |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
(b) Check the fuses and relays.
(c) Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
|
| 4. | CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check for CAN communication system DTCs.
Click here
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
| B | | GO TO CAN COMMUNICATION SYSTEM |
|
| 5. | CHECK DTC OUTPUT (AIRBAG SYSTEM)* |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
| B | | GO TO AIRBAG SYSTEM |
|
| 6. | CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)* |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
| B | | GO TO OCCUPANT CLASSIFICATION SYSTEM |
|
| 7. | CHECK COMBINATION METER ASSEMBLY |
(a) Check the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.
OK:
The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.
| NG | | GO TO METER / GAUGE SYSTEM |
|
| 8. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
| B | | GO TO STEP 10 |
|
| 9. | OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test
Click here
(b) Terminals of ECU
Click here
(c) On-vehicle Inspection
Click here
|
| 10. | REPAIR OR REPLACE |
|
| 11. | CONFIRMATION TEST |
| NEXT | | END |
Customize Parameters
Terminals Of EcuLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: Torque Sensor Zero Point Adjustment Undone (C1515)
DESCRIPTION This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not been performed. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condit ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Window Regulator Motor (for Rear Door): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) ba ...