DESCRIPTION
The side collision sensor RH circuit (bus 1) consists of the airbag sensor assembly, door side airbag sensor RH and rear airbag sensor RH.
The door side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if the airbags, pretensioners and selectable force limiter should be deployed.
These DTCs are stored when a malfunction is detected in the door side airbag sensor RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B166C | Front Door Pressure Sensor RH |
|
| Comes on | Does not apply to test/check mode |
| B166F | Front Door Pressure Sensor Threshold Malfunction (RH) |
|
| Comes on | Does not apply to test/check mode |
WIRING DIAGRAM
Click here
CAUTION / NOTICE / HINT
NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
PROCEDURE
| 1. | CHECK DOOR SIDE AIRBAG SENSOR RH |
| (a) Turn the engine switch off. |
|
(b) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Interchange the door side airbag sensor RH with LH and connect the connectors.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG), and wait for at least 60 seconds.
(f) Clear the DTCs stored in memory.
Body Electrical > SRS Airbag > Clear DTCs(g) Turn the engine switch off.
(h) Turn the engine switch on (IG), and wait for at least 60 seconds.
(i) Check for DTCs.
Body Electrical > SRS Airbag > Trouble CodesHINT:
Codes other than DTCs B166C, B166F, B167A and B167E may be output at this time, but they are not related to this check.
| Result | Proceed to |
|---|---|
| DTC B166C or B166F is output. | A |
| DTC B167A or B167E is output. | B |
| DTCs B166C, B166F, B167A and B167E are not output. | C |
(j) Turn the engine switch off.
(k) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(l) Return the door side airbag sensor RH and LH to their original positions and connect the connectors.
| A | | REPLACE AIRBAG SENSOR ASSEMBLY |
| B | | REPLACE DOOR SIDE AIRBAG SENSOR RH |
| C | | USE SIMULATION METHOD TO CHECK |
Seat Belt Buckle Switch (LH) (B1656)
P Seat Airbag Active Mode Indicator (B1660)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headlight Cleaner Motor: Inspection
INSPECTION PROCEDURE 1. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY HINT: This check should be performed with the headlight cleaner motor and pump assembly installed on the washer jar. (a) Fill the washer jar with washer fluid. (b) Connect a battery positive (+) lead to terminal 2 of the he ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Parts Location
PARTS LOCATION ILLUSTRATION *1 TELEPHONE MICROPHONE ASSEMBLY *2 ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY - AMP FUSE - ECU-IG1 NO. 8 FUSE - RADIO NO. 1 FUSE - RADIO NO. 2 FUSE *3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-ACC FUSE - ECU-DCC NO. 2 FUSE - METER FUSE - MET ...