INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT DETECTION ECU
| (a) Engage the claw to install the occupant detection ECU. NOTICE: If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one. |
|
(b) Connect the 2 connectors.
NOTICE:
When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
2. INSTALL FRONT SEAT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
Click here
3. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad: On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the horn button assembly. PROCEDURE 1. INSPECT HORN BUTTON ASSEMBLY (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here (b) Visually ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Inner Belt Assembly(for Rh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat inner belt assembly removal/installation are shown below. Necessary Procedure After Parts Remo ...