TERMINALS OF ECU
OCCUPANT DETECTION ECU
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| b10-1 (SVC1) - b10-5 (SGD1) | R - G | Front occupant classification sensor LH power supply | Engine switch on (IG) | 11 to 14 V |
| b10-2 (SVC3) - b10-6 (SGD3) | GR - W | Rear occupant classification sensor LH power supply | Engine switch on (IG) | 11 to 14 V |
| b10-3 (SIG1) - b10-5 (SGD1) | P - G | Front occupant classification sensor LH signal | Engine switch on (IG) | Pulse generation |
| b10-4 (SIG3) - b10-6 (SGD3) | SB - W | Rear occupant classification sensor LH signal | Engine switch on (IG) | Pulse generation |
| b10-5 (SGD1) - A-10 (GND) | G - - | Front occupant classification sensor LH ground | Always | Below 1 V |
| b10-6 (SGD3) - A-10 (GND) | W - - | Rear occupant classification sensor LH ground | Always | Below 1 V |
| A-4 (CANL) - A-10 (GND) | - | CAN communication line | Engine switch on (IG) | Pulse generation |
| A-5 (CANH) - A-10 (GND) | - | CAN communication line | Engine switch on (IG) | Pulse generation |
| A-6 (IG2) - A-10 (GND) | - | Power source | Engine switch on (IG) | 11 to 14 V |
| A-7 (BSW) - A-9 (BGND) | - | Passenger side buckle switch signal | Always | Pulse generation |
| A-9 (BGND) - A-10 (GND) | - | Passenger side buckle switch ground | Always | Below 1 V |
| A-10 (GND) - Body ground | - | Ground | Always | Below 1 V |
Problem Symptoms Table
Diagnosis SystemLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Seat Outer Belt Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY (a) Engage the guide and temporarily install the front shoulder belt anchor adjuster ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Combination Light Assembly (w/ Rear No. 2 Seat): Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR COMBINATION LIGHT CAP (for LED Type Turn Signal Light) (a) for TMMC Made: (1) Remove the rear combination light cap. HINT: Use ...