ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear airbag sensors.
PROCEDURE
1. INSPECT REAR AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
2. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check the rear airbag sensors for defects if a quarter panel of the vehicle or the area around a quarter panel is damaged.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the rear airbag sensor with a new one.
3. INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)
(a) When airbags have deployed as the result of a collision, be sure to replace all rear airbag sensors in the damaged areas (anywhere in need of repair).
(b) Visually check the rear airbag sensors in undamaged areas for defects.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found or a rear airbag sensor has detected a major collision, replace the rear airbag sensor with a new one.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Millimeter Wave Radar Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Door Speaker: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Click here 2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE ...