OPERATION HISTORY LIST
NOTICE:
OPERATION HISTORY
HINT:
The certification ECU (smart key ECU assembly) stores the operation history of the smart access system with push-button start and it can be read using the Techstream.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Smart Access / Utility / Operation History / Certification ECU operation log of ID code registration, Radio wave interference or Radio wave interference 2.
Body Electrical > Smart Access > Utility| Tester Display |
|---|
| Operation History |
(e) Following the instructions on the screen, save the operation history.
| Operation History List |
|---|
| Auto Entry Mode Switch History |
| Auto Entry Wireless Operation History |
| Warning Operation History |
| Engine Start |
| System Start Operation |
| Customize (Auto Entry Cancel) |
| Customize (Door Unlock Mode Switch) |
| Radio wave interference (RF Signal Received) |
| Engine Start (inactive) |
| System Start Operation (inactive) |
| Remote Engine Starter (inactive) |
| Auto Entry Unlock (inactive) |
| Registration Function (Reason for Non-operation) |
| Auto Entry Lock (inactive) |
| Engine Start Inactive (Brake/Clutch System) |
| Radio Wave Interference (RF Reception Not Available) |
| Engine Start Inactive (Steering Lock System) |
HINT:
Some items are not displayed depending on the vehicle.
Data List / Active Test
Open in Driver Side Electrical Antenna Circuit (B27A1)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Camera System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Before performing troubleshooting for the front camera system, perform troubleshooting for the pre-collision system.
Click here
If a pre-collision system related warning message is displayed on the multi-information display, refer to How to Proceed with Troublesh ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rocker Panel Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY Click here 2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY Click here 3. REMOVE NO. 6 ROCKER PANEL ...