REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY
Click here
2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY
Click here
3. REMOVE NO. 6 ROCKER PANEL MOULDING PROTECTOR
Click here
4. REMOVE QUARTER PANEL WHEEL OPENING MOULDING
Click here
5. REMOVE ROCKER PANEL MOULDING COVER
(a) Disengage the 2 claws as shown in the illustration to remove the rocker panel moulding cover.
| Remove in this Direction |
HINT:
Use the same procedure for the other rocker panel moulding cover.
6. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY
(a) Apply protective tape around the rocker panel moulding assembly and door as shown in the illustration.
| Protective Tape | - | - |
| (b) Remove the 2 screws and 9 clips. |
|
(c) Disengage the 6 clips as shown in the illustration to remove the body rocker panel moulding assembly.
| Remove in this Direction |
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Heater Control(for Rear Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat heater control removal/installation are shown below. Necessary Procedure After Parts Removed/Instal ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System): Calibration
CALIBRATION NOTICE: When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the intuitive parking assist system may not operate correctly. ADJUST INTUITIVE PARKING ASSIST SYSTEM (a) The necessary procedures (adjustment, calibration, initialization ...