DESCRIPTION
This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code.
PROCEDURE
| 1. | CHECK DTC |
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and wait for 10 seconds or more.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(f) Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble CodesOK:
No DTCs are output.
| NG | | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
| 2. | CHECK VEHICLE OPERATION HISTORY |
(a) Check for vehicle control history and note any codes that are output.
Click here
| Result | Proceed to |
|---|---|
| No vehicle control history is output | A |
| Any vehicle control history is output | B |
| B | | GO TO VEHICLE CONTROL HISTORY |
|
| 3. | REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
| NEXT | | PERFORM DCM ACTIVATION |
Green Indicator Remains Off
Unable To Connect To Call CenterLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Pressure Control Solenoid "D" Circuit Open (P271313)
DESCRIPTION Refer to DTC P27137F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P271313 Pressure Control Solenoid "D" Circuit Open 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
Engine is running
Shif ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Camshaft Position Sensor: Installation
INSTALLATION PROCEDURE 1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2) (a) Apply a light coat of engine oil to the O-ring of the VVT sensor. NOTICE: If reusing the VVT sensor, be sure to inspect the O-ring. (b) Apply adhesive to 2 or 3 threads at the end of the bolt. Adhesive: Toyota Genuine ...